This can be a demoralizing experience. You have spent oil and oil filter hung like a leech. It will not come off.
The best way to fix it is not to have it happen in the first place. You can remember to put oil on the gasket and hand tighten the spin on the filter sufficiently to close it. It might be better to use silicone oil instead of oil on the gasket, but now it does not matter because the dam objects are jammed.
One way is to move a large screwdriver through the side of the filter and stick it around. This will work, but it leaves a huge mess and often destroys filters that leave only the base installed. Then you attach the screwdriver in the small hole around the threaded middle hole and with the hammer drive from the bottom of the filter.
Remember that the filter is not jammed in the thread. It's stuck on a compressed gasket between the filter and the block. If you can break that bond, the filter will be freed easily. So, take a razor blade one edge and work between the gasket and the block and slide it along the gasket. You may need to use a thin screwdriver instead, but be careful. You do not want to damage the engine surface injected oil filter.
Required Tools for this Project
Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.
- Utility knife
Required Materials for this Project
Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.
- Adhesive-backed sandpaper, coarse grit
Get a better oil filter grip
- Add grit to get a better grip
Cut a folder and drop it on the band style filter lock. Next, remove the adhesive layer and push it into place.
2. Get a filter wrench with built-in grip
Slide a Swivel-Gripper filter wrench toward the base of the filter. Rotate the handle to force the grit into the metal. Then swivel the handle and twist off the filter.
We've all done it: we've turned on the oil filter so it can be tied up. If you think you can eliminate it by swinging a long screwdriver through the tin and twisting, think again. The screwdriver will only open and you will be soaked with oil. When you are finished with a disaster, the filter will still get stuck and you will feel frustrated again.
To remove a clogged filter, use a ribbon lock that you limit with abrasive abrasive abrasive abrasive. Or the spray adhesive behind the conventional sandpaper. Better yet, buy a filter wrench with a rough grit welded to the inside of the belt. The Lisle Swivel-Gripper anti-slip filter meter is available in five sizes and costs around $ 12. Available on amazon.com. Slide the filter-sealing tape along the road near the bottom of the filter. Then squeeze and turn.
Video How to remove a stuck oil filter
Tidak ada komentar:
Posting Komentar